Chapter3 Handling Printing from the First Label (Auto cutter model only) If the [Media Detect] setting has been set to [Gap], you cannot print on the first label (printed from the second label) at the first time printing after loading paper. However, for the auto cutter model, even when [Gap] is selected as [Media Detect], you can prevent missing of the first label by following the procedure below. • When you perform the following and print, auto cut is disabled. • If there is a difference between a label actually used and the settings on the printer driver, the print quality may decline. CAUTION • For the peeler model, there is no measure to print from the first label.
• For the auto cutter model, this procedure is not necessary if [Media Detect] is [Black Mark] or [None]. 1 Cut off the backing paper from 2 mm (0.08 inches) away from the top edge of the first label. Paper feed direction 2 mm (0.08 inches) Label (first) Label 2 On the operation panel of the printer, select [Not Feed] from [Actions when Replacing Media]. [Menu] - [General Settings] - [Printer Settings] - [Print Options] - [Actions when Replacing Media] - [Not Feed] The default setting is [Feed] (for peeler model) or [Feed without Cut] (for auto cutter model). 3 Specify a length of the label, and a gap between labels. ( "Media Settings" on page 48 ) 4 Load paper, and then print.
For the paper loading procedure, see "Opening the Paper Cover" on page 49 . 290