EPSON — Label Media Settings

Chapter3 Handling Label Media Settings • When using die-cut labels, use kiss cut die-cut label paper that has waste parts around each label. However, there should be no waste parts at both side edges of roll paper. • The Windows driver and PrinterSetting perform the following input value check and automatic correction. ∗ The input value check makes sure that the Left & Right Gap multiplied by 2 and added to the label width does not exceed the maximum media width. Furthermore, if the input value exceeds the maximum (min- imum) media width, the upper limit (lower limit) of the input value is restricted so that it does not exceed the maximum (minimum) media width.

• The input value check and automatic correction are only performed with the Windows driver and Printer Settings. Therefore, if you use any other driver to make layout settings such as the Left & Right Gap and label width, and the print range is exceeded, only the section within the printable range will be printed. 292