Chapter3 Handling Restricting Operation of the Operation Panel (Lock Setting function) The [Lock Setting] function allows an administrator to lock the paper settings, printer settings, and/or system administration related settings to prevent unauthorized changes. The procedure is as follows. 1. Set an administrator password. ( Page 296 ) 2. Enable the [Lock Setting] function. ( Page 297 ) 3. Set the settings to be locked. ( Page 297 ) The following settings can be locked. General Settings: Settings that are rarely changed once you configure them, such as the network settings and date/time settings. Media Settings: Settings related to media (paper) Printer Settings:
Menus for adjusting or maintaining the printer and the print settings To know which menu or setting can be locked, see "Operation Panel Settings" on page 229 . Setting an Administrator Password If there is a password label applied to the rear of the printer, the value for "PASSWORD" is the initial value. In the example shown, the initial password is 03212791. 1 Select [Menu] - [General Settings] - [System Administration] - [Security Settings] - [Admin Settings] in that order. 2 Select [Admin Password] - [Register] in that order. 3 Enter an administrator password, and then select [OK] on the screen.
Set the new password using alphanumeric characters and symbols, with a length of eight or more characters but no more than 20 characters. 4 Enter the password again, and then select [OK] on the screen. 5 When a message is displayed, press the OK button. 296