Appendix Roll paper Die-cut Label with perforation (without black marks) Gap between pages Cut position Backing paper Label area 369 Backing paper width Paper fe length Perfor Label Labels between Side e Gap baseli ste part Label width Waste pa Label length Label width Side e baseli Waste pa Labels between Gap ste part Form Roll paper Backing paper width 25.4 to 112 mm (1 to 4.41 inches) Label width 21.4 to 108 mm (0.84 to 4.25 inches) Label length When auto cut is not used: 8 to 609.6 mm (0.31 to 24 inches) (up to 24 inches) When auto cut is used: 15 to 609.6 mm (0.59 to 24 inches) (up to 24 inches) Gap between Labels When auto cut is not used:
2 to 6 mm (0.08 to 0.24 inches) When auto cut is used: 3 to 6 mm (0.12 to 0.24 inches) Waste part on the left and right 2 ± 0.5 mm (0.08 ± 0.02 inches) Label corner R 1.5 mm (0.06 inches) or less Paper thickness Plain Paper/Matte Paper/Synthetic/Texture Paper/Glossy Paper/Glossy Film/ High Glossy Paper 0.12 to 0.24 mm (0.005 to 0.009 inches) Roll paper core inner diameter 76.2 ± 0.5 mm (3 ± 0.02 inches) Roll paper outer diameter 203.2 mm (8 inches) or less Winding direction Print side must be facing outside (facing inside is unusable) Perforation interval Three (hole portion) to one (no hole portion) Perforation form Usable if a hole is located at side edges