Appendix Paper detection method • When using die-cut label without black marks, the light transmission rates must be: 40% or higher for the backing paper, and 23% or lower for the labels. • When using paper with black marks, the black mark reflectance rate must be 10% or lower, and the white reflectance rate is 70% or higher. Electrical Specifications *Based on Epson evaluation conditions 397 Sensor Label sensor (Transmissive photo interrupter) Black mark sensor (Reflective photo interrupter) Judging method The label sensor and black mark sensor detect the position of the paper.
Item CW-C6000 Series CW-C6500 Series Power supply Power supply through a power connector Rated voltage 100 to 240 V Rated current 0.9 A Power consumption* Operating* 100V: Average of approx. 39.4 W 230V: Average of approx. 38.6 W 100V: Average of approx. 39.5 W 230V: Average of approx. 38.7 W Standby 100V: Average of approx. 7.51 W 230V: Average of approx. 5.82 W 100V: Average of approx. 7.51 W 230V: Average of approx. 5.82 W Power off 100V: Average of approx. 0.08 W 230V: Average of approx. 0.24 W 100V: Average of approx. 0.08 W 230V: Average of approx. 0.24 W