Chapter2 Setup How to Configure the Network Settings Follow the procedure below to set up the IP address of the printer. • To connect to the printer via Ethernet, the network settings are required. When connecting to the printer via USB, the network settings are not required. • Before starting the network settings, ask your network administrator for information required for the network settings. 1 Turn the printer on. 2 Select [Menu] and then press the [OK] button. 3 Select [General Settings] and then press the [OK] button. 4 Select [Network Settings] and then press the [OK] button. 5 Select [Advanced] and then press the [OK] button. 6 Select [TCP/IP] and then press the [OK] button.
7 Select [Obtain IP Address] and then select [Auto] or [Manual] using the [OK] button. When you select [Auto], the network setting is complete. When you select [Manual], proceed to step 8. 8 Enter the IP address and the subnet mask. Select a setting to change and then press the [OK] button to enter the information. 9 Select [Start Setup] and then press the [OK] button. The network setting is now complete. 47