Chapter2 Setup Loading Paper This section describes how to load and replace paper. As shown below, the procedure of replacing paper differs depending on the size and whether paper has been/is going to be supplied from inside or outside. Videos that show the procedure are also available. Click the URL below to view the videos. https://support.epson.net/p_doc/790/ > c IMPORTANT • To supply roll paper from outside the printer, prepare an external paper feeder and paper rewinder by yourself. For more details, see "Requirements for External Devices" on page 411 . • With the peeler model, you cannot supply fanfold paper from outside the printer.
• When replacing paper with a different shape, form, or type of paper, change the paper settings either from the operation panel or on the printer driver before loading the paper. ( "Operation Panel Settings" on page 229 , "Media Source and Media Detection Settings" on page 85 , "User- Defined Paper" on page 87 ) 50 Supply from Inside (Internal) Paper is supplied from inside the printer. Set roll paper attached to the spindle into the printer. Supply from Outside (Rear Feed) Paper is supplied from outside the printer. Place roll paper or fanfold paper behind the printer.
Models Supply from Inside (Internal) Supply from Outside (Rear Feed) Fanfold paper Roll paper Auto cutter model • Paper loading: Page 51 • Paper removal: Page 66 • Paper ejection at paper end: Page 70 • Paper loading: Page 55 • Paper removal: Page 66 • Paper ejection at paper end: Page 70 "Requirements for External Devices" on page 411 Peeler model • Paper loading: Page 59 • Paper removal: Page 68 • Paper ejection at paper end: Page 71 "Requirements for External Devices" on page 411