Chapter2 Setup Installing the Ink Packs and Charging Ink First Time Shake and then install the ink packs following the on-screen instructions. When you close the cover, a message that confirms whether to start initial ink charging is displayed. Select [Yes] to start the initial ink charging. When you see a message saying that the initial ink charging is finished, select [OK]. It takes about 10 minutes for the initial ink charging. The time differs according to circumstances. • If a different type of black ink from the selected black ink type is installed in the printer, initial ink charging will not be possible. The black ink type cannot be changed after the initial ink charging has started.
• The time it takes to charge ink depends on the situation. • Never open the printer covers or turn off the power while ink charging is in progress. If these operations are performed during ink charging, ink will be significantly consumed and the ink packs may need to be replaced before charging is complete. • Do not grip the ink pack tightly. Ink may leak from the pack. CAUTION Check below for instructions on how to replace the ink packs. U "Replacing the Ink Packs" on page 84 49