Chapter2 Setup Connecting to a Host Device • When connecting via USB or Wired LAN Connect the corresponding interface cable to the connector on the right side of the printer. • When connecting via Wireless LAN Connect the optional OT-WL06 to the connector on the right side of the printer. Connecting to Wired LAN Connect to the network with a LAN cable and check the connection. 1 Connect the printer and a hub (or LAN switch) with a LAN cable. 2 Select [Menu] on the home screen. 3 Select [General Settings] - [Network Settings] - [Connection Check]. The result of the check is displayed. Confirm that the printer is properly connected to the network.
Connecting to Wireless LAN (Wi-Fi) using a Wireless LAN Router By connecting the optional wireless LAN unit (OT-WL06) to the printer, the printer can communicate over a wireless LAN. There are several ways to connect the printer to a wireless LAN (Wi-Fi). Select the connection method that best suits your environment and conditions. The following two connection methods using a wireless LAN router are introduced here. For information (SSID, password) of the wireless LAN router (access point), please check your router or if inaccessible then contact your network administrator.
• "Connecting using SSID and Password" on page 53 • "Connecting using Push Button (WPS)" on page 57 • If is not displayed on the home screen, check that the optional wireless LAN unit is properly connected, and turn the printer off and then back on. • When Wi-Fi Direct is enabled, the printer acts as an access point and can be connected to up to eight devices. U "Connecting to Wireless LAN (Wi-Fi) using Wi-Fi Direct" on page 59 52