Chapter2 Setup Ejection Angle of Printed Paper Ensure that the printed paper is ejected straight from the ejection slot as shown in the figure below. If paper is not ejected straight due to obstructions or other factors, printing may be distorted. • When the printer starts printing, it retracts the label paper slightly to align the print start position with the next label to be printed. If the printer is located away from the computer, the printer user cannot know when the next print run will begin and when the label paper will be retracted.
Therefore, when handling paper ejected from the printer, such as loading printed label paper into the rewinder, be sure to press the (pause) button to stop the printer before doing so. • If you need to separate the fanfold paper along the perforations after printing, do so after pressing the (pause) button to stop the printer, or use the cut button to separate the paper. If the printer retracts the paper to start next printing while you manually separate the paper, a paper jam will result. • Do not touch the paper during printing, as misalignment of the paper may cause a paper jam or mis- alignment of the print position. 77