5 XF 95 series General REPAIRING WIRING At the top is the DAF no. of the contact shown. Roman numerals I and II, shown below the illustrations, refer to the contact crimping tool to be used. The numeral or letter added to Roman numeral I or II indicates the hole in the contact crimping tool in which the contact is to be placed. Roman numerals III to VII refer to the type of ejector tool to be used for removing the contact from the connector. The information at the bottom refers to the core section suitable for the contact. W 5 03 018 3 Contact kit B Additional contact crimping and ejector tools are required for SCAT contacts and for micro-timer contacts. Contact kit B (DAF no.
1240065) is available for this purpose. There is a sticker on the inside of the kit to facilitate selection of the contact, contact crimping tool and ejector tool (to be used in the same way as for contact kit A). Note: The proper ejector and the proper contact crimping tool for each contact can also be found through ‘Parts Rapido’. 200303 1-3