5 REPAIRING WIRING Removal and installation XF 95 series 1. Push the wire with contact forwards (1). The locking bolt (2) is now free from the connector (3). 2. Push the proper ejector tool (4) into the front of the connector. This will push the locking bolt (2) down. 1 2 3 3. The contact can now be removed by gently pulling the wire. Note: If the wire is pulled before the ejector tool pushes the locking bolt down, the contact will only be fixed in the connector even more. 4 3 E501482 Contacts are also used in which the locking bolt (2) is on the rear of the connector (3). 1. Pull the wire and contact backwards (1). The locking bolt (2) is now free from the connector (3). 3 1 2.
Push the proper ejector tool (4) into the back of the connector. This will push the locking bolt (2) up. 2 3. The contact can now be removed by gently pushing the wire forwards. Note: Here the locking bolt works exactly the opposite to the usual connectors. 4 Application examples: - EMAS pressure sensor connector - Accelerator sensor connector, CF series / XF series E501696 2-4 200303