Determining the wire routing direction for the back plate Before mounting the controller, determine the wiring direction and remove a piece of the controller’s back plate accordingly (i.e.: a, b, c). The wiring can be routed from the top, the left, or the bottom of the back cover. Remove a piece of the back plate according to the following figure. After removing a thin piece with a tool such as clippers, remove burrs using a file, etc. a a Wiring from top b Wiring from left c Wiring from bottom b c In case you are routing the wiring from the rear, you don’t have to remove anything.
When routing the wiring from the top, rear, left, or bottom, be sure to route the wiring to the upper casing before securing the back plate. CAUTION 5