Using Windows 98 Using the Docking Solutions Note Hot Swap is not supported in the Docking System module bay. You must restart the OmniBook when changing modules in the Docking System module bay. Hot Docking is not supported with an external video adapter is installed in the Docking System. Always shutdown and turn off the OmniBook before docking or undocking the OmniBook if you are using an external video adapter. Also do not suspend the OmniBook while using an external video adapter. Power Management is not supported with an external video adapter.
To install the HP Notebook docking system support If you are going to use the HP Notebook Docking System you must install a new IDE driver in Windows 98. Perform this procedure before inserting the HP Notebook into the dock. The HP Notebook Docking System IDE driver is located on the Recovery CD at \HP\DRIVERS\W98\DOCKING\IDE and \HP\DRIVERS\W98\DOCKING\SCSI. 1. From the Start menu, click Run, and then enter D:\HP\DRIVERS\W98\Docking\IDE\SETUP.EXE and click OK, 2. When prompted to install the CMD Bus Master IDE Driver, click Yes. 3. When prompted to restart, click No. 4. Open a DOS window and type the following: D:
CD \HP\DRIVERS\W98\DOCKING COPY HWP2280.INF C:\WINDOWS\INF /Y CD SCSI COPY SYMC8XX.INF C:\WINDOWS\INF /Y COPY SYMC8XX.MPD C:\WINDOWS\SYSTEM\IOSUBSYS /Y 5. Close the DOS window and shut down the HP Notebook. 6. Insert the HP Notebook in the HP Notebook Docking System and power on the HP Notebook. 7. Windows 98 will detect the “PCI standard PCI to PCI bridge”. Click Next to continue. 8. Click Next to Search for the best driver for your device. 110 Corporate Evaluator’s Guide