Using Windows 95 Installing Windows 95 13. Click Finish to reboot. 14. The driver is installed when Windows reboots. To install USB support If you have installed Windows 95 OSR 2.x and you wish to use USB, you will need to install USB support. These drivers are located on the Recovery CD in \HP\DRIVERS\W95\USB. 1. Copy the \HP\DRIVERS\W95\USB directory and its contents from the Recovery CD to C:\WINDOWS\TEMP. 2. Open the MS-DOS Prompt. 3. Type: CD \WINDOWS\TEMP\USB and press Enter. 4. Type: ATTRIB -R *.* /S and press Enter. 5. Type: OEMUSB /Q:1 /T:C:\WINDOWS\TEMP\USB\USB1 /N:E and press Enter. 6. Type: USBUPD2 /Q:1 /T:C:\WINDOWS\TEMP\USB\USB2 /N:E and press Enter. 7.
From Control Panel, double-click System, then click Device Manager. 8. Remove the “PCI Universal Serial Bus” device under Other Devices. Click OK in the Confirm Device Removal dialog box. 9. Click on Refresh to redetect the USB Controller. 10. Click Next to search for the driver. 11. Click Other locations to search for the driver. 12. Browse to C:\WINDOWS\TEMP\USB\USB1 and click OK. 13. Click OK. 14. Click Finish to restart the HP Notebook. The driver loads when Windows reboots. To install accessory module hot swap support (Agate Tioman) If you’ve installed a retail version of Windows, you can install software that will allow accessory modules to be changed in the unit without rebooting.
This software must be installed manually. Corporate Evaluator’s Guide 123