Using Windows 95 Using the Docking Solutions Note Hot Swap is not supported in the Docking System module bay. You must restart the OmniBook when changing modules in the Docking System module bay. Hot Docking is not supported with an external video adapter is installed in the Docking System. Always shutdown and turn off the OmniBook before docking or undocking the OmniBook if you are using an external video adapter. Also do not suspend the OmniBook while using an external video adapter. Power Management is not supported with an external video adapter.
To install the HP Notebook docking system support If you are going to use the HP Notebook Docking System you must install a new IDE driver in Windows 95. Perform this procedure before inserting the HP Notebook into the dock. The HP Notebook Docking System IDE driver is located on the Recovery CD at \HP\DRIVERS\W95\DOCKING\IDE and \HP\DRIVERS\W95\DOCKING\SCSI. 1. Copy the CMDDMA.INF file from \HP\DRIVERS\W95\DOCKING\IDE to C:\WINDOWS\INF. 2. Insert the HP Notebook in the HP Notebook Docking System. 3. Windows 95 will build a Docking Hardware profile. 4. Click OK in the Configuration Setup Window. 5.
When prompted for the IDE drivers, enter \HP\DRIVERS\W95\DOCKING\IDE on the Recovery CD and click OK. 6. From Control Panel, double-click Display, then click Settings. 7. Change the Display Resolution to the appropriate setting and click OK. 8. Click Yes to save your change. 9. From Control Panel, double-click System, then click Device Manager. 10. Open “PCI NCR C810 SCSI Host Adapter” under SCSI Controllers. 11. Click Driver then Update Driver. 12. Click Select from a list and double-click PCI NCR C810 SCSI Host Adapter. 13. Click Other Locations. 14. Enter the \HP\DRIVERS\W95\DOCKING\SCSI directory on the Recovery CD and click OK. Corporate Evaluator’s Guide 127