Using Windows NT 4.0 Installing HP/3Com 10/100 Ethernet+ 56K Global Modem Mini-PCI Card Support 5. Click Have Disk. Enter the directory which contains the LAN drivers (\HP\Drivers\NT4\LAN), and then click OK. 6. When the Select OEM Option window opens, select 3Com 10/100 Mini PCI Ethernet Adapter, and then click OK. 7. The Network Adapters list shows a check mark next to the 3Com network adapter. Click Next to continue. 8. In the Network Protocols list, place a check mark next to each network protocol required for your site, and then click Next. 9. In the Network Services window, there are four default options.
Unless you are following specific guidelines from your MIS department, select the default settings. 10. Click Next to install the selected components, and then click Next again. 11. When prompted, enter the path to the Windows NT installation files (C:\OPTIONS\i386), and then click Continue. 12. When the system prompts again for NT files, enter D:\HP\Drivers\NT4\LAN. 13. In the 3Com network adapter window, accept the default settings, and then click Continue. Values are assigned automatically. 14. Answer the network questions. If you don’t the answers ask your network administrator. 15. When the window for enabling or disabling protocols opens, click Next. 16.
When NT is ready to start the network, click Next to copy the network files. 17. Provide your computer name and workgroup or domain name when prompted. 18. When the system displays “Networking has been installed on your computer,” click Finish. 19. When prompted to reboot the computer click Yes. 20. If you had Service Pack 3 or later installed prior to setting up the network adapter, you should reinstall it after NT has finished rebooting. To install modem support If you have installed retail Windows and your HP Notebook contains a built-in 3Com 56K V.90 Mini PCI Modem, you need to install the modem drivers.
The modem drivers are contained in the \HP\DRIVERS\NT4\MODEM\3COM subdirectory 144 Corporate Evaluator’s Guide