Mitsubishi — 3.8.2.1 Set / Reset / Maintained / Momentary Buttons

Chapter 3 Creating and Editing Screens Revision May, 2010 3-99 Property Description of General Buttons Function The user can modify the element characteristic directly without re-create a new element. The elements that their characteristics can be modified directly by using this option are: Set button, Reset button, Momentary button and Maintained button these four kinds of buttons. Push Time (second) Use this option to set the active time of the button. When this option is set, the button will be active after pressing the button longer than the setting time. Using this option can avoid malfunction. The range is within 0 ~ 10 seconds.

User Security Level Use this option to set the user priority for pressing this element. Only the priority that is equal to or higher than the current setting can use this element. Set Low Security Use this option to force the current priority to be the lowest after the button is pressed. This can prevent the misoperation made by the user (operator). InterLock Address InterLock Level When InterLock Address is set to be ON or OFF (this is determined by the property of “InterLock Level”), this button can be enabled. Before Execute Macro If this option is set, when the user presses the button, the system will execute the command of this macro first and then perform the operation of this button.

But, if the state of the button is not triggered by pressing the button (via macro or external signal), the command of this macro will not be executed. After Execute Macro If this option is set, when the user presses the button, the system will perform the operation of this button first and then execute the command of this macro. But, if the state of the button is not triggered by pressing the button (via macro or external signal), the command of this macro will not be executed. Enable the confirm window When this option is set, an Action Confirm dialog box will appear to prompt the user everytime when the the button is pressed.

Invisible Address When this option is set to On, this button element will be invisible. X Used to set X coordinate Y Used to set Y coordinate Width Used to set the element width Height Used to set the element height