Mitsubishi — 3.8.2.5 Increment / Decrement

Chapter 3 Creating and Editing Screens Revision May, 2010 3-107 Property Description of Increment / Decrement Buttons Trigger Trigger Type The user can use this setting to trigger the designated controller address to be ON before or after writing the setting value. Please note that this function can only trigger the controller address to be ON. If the controller address needs to be triggered again, the user should set the address to be OFF manually. Range Setting Data Length There are 16bits Word and 32bits Double Word two options. Memory There are following data format provided: Word/Double Word 1. BCD 2. Signed BCD 3. Signed Decimal 4. Unsigned Decimal 5.

Hex Inc/Dec Used to set the increasing and decreasing value when pressing the Increment and Decrement button every time. Limit Used to set the limit of increment and decrement values. Press the OK button, and HMI will examine the increment and decrement values entered and limit the value, if necessary, by referring to the selected data length and data format.。 User Security Level Use this option to set the user priority for pressing this element. Only the priority that is equal to or higher than the current setting can use this element. Set Low Security Use this option to force the current priority to be the lowest after the button is pressed.

This can prevent the misoperation made by the user (operator). InterLock Address InterLock Level When InterLock Address is set to be ON or OFF (this is determined by the property of “InterLock Level”), this button can be enabled.