Mitsubishi — 3.8.3 Meter Elements

Chapter 3 Creating and Editing Screens Revision May, 2010 3-119 Property Description of Meter Elements Setting Target Value Color The user can decide if the target value display or not by using this option. If this option is set, the target value and its color set by the user will display just like the figure shown below: (Here we set the target value is 60 and its color is in blue.) Ranges (Enable range setting) Please refer to the description of Low & High Region Color.

Variable target/range limits When the target value and low & high limit is a variable value, the low limit address is Read Address+1, the high limit address is Read Address+2 and the address of target value is Read Address+3. Integral Digits Fractional Digits Use this option to determine the digit number of integer and decimal fraction. The digit number is not a real digit number value. It is only the display format. Low Region Color High Region Color This option is available and displayed in the property table only when the “Ranges” option in the Detail Setup dialog box is selected.

If the user sets the low limit value is 30 and the color of low limit region is in green, and then set the high limit value is 70 and the color of high limit region is in red, the meter element will be shown as the figure below: Stitch Color Set the stitch color of the meter element. Grid Color Set the grid color of the meter element. Scale Region Number It is used to set the scale region number of the meter element. The user can use the up or down buttons to increase or decrease the scale region number. The setting rang is within 1 ~ 10. Rule Color Set the rule color of the meter element.

X Used to set X coordinate Y Used to set Y coordinate Width Used to set the element width Height Used to set the element height