Chapter 3 Creating and Editing Screens 3.8.10 Input Elements Fig. 3-8-27 Input Elements 3.8.10.1 Numeric Entry Revision May, 2010 3-157 Property Description of Numeric Entry Elements After pressing this numeric entry element on the screen, a system built-in numeric keypad (TEN-KEY) will show up and the user can use it to input the setting value directly. When ENTER key is pressed, HMI will send the input setting value to the corresponding register. The maximum and minimum input setting values are all user-defined. The user can also specify the trigger mode to trigger the designated PLC address before or after writing the setting value.
Write Address Read Address The address can be internal memory or the controller address. (Please refer to Table 3-8-2 Property Description of General Buttons.) Text Size Text Color The user can set the text size and text color that provided by HMI to determine the text display on the element. HMI provides 8~64 kinds of default text font for the user to use. Border Color Background Color Border Color option can be set only when the style of the numeric entry element is selected as Raised and Sunken. The style of the element below is selected as “Rasied”. Its background color is set to blue and its border color is set to red.
(If the style of the element is set to Transparent, the Border Color and Background Color these two options are disabled.) Style Standard Raised Sunken Transparent Leading Zero The following figures show the difference if the user selects the Leading Zero option. (Please note that the integral digits are set to 4.) (If Yes is selected) (If NO is selected)