Chapter 3 Creating and Editing Screens 3-242 Revision May, 2010 History Buffer Setup Dialog Box Buffer Properties Sample Cycle (ms) Set the sampling cycle time for reading the address (how long it takes to read the address one time). If the Trigger option is PLC, this option will be unavailable. The range of the sampling cycle time for one day is 0 – 86400000 ms. Sample Number This option is used with the Auto Stop option. If the Auto Stop option is selected, HMI stops recording the data after the numbers of records have reached the setting value of Sample Number option.
If the Auto Stop option is not selected, when record number of data exceeds the setting value of Sample Number option, it will delete the first record and insert the new record into the last address. For example, if the setting value is set to 100 and the number of records in history exceeds 100, the first record will be deleted and the second record will become the third record, the third record will become the forth record…and the 100th record will become the 99th record. Therefore, the new record (101st record) will become the 100th record.
The record data will be name as “History.dat” and the user needs to use the software, FlashTransfer which is attached in the HMI editing software, to open this file. FlashTransfer will sort and list the history data by record time automatically. Stamp Time and Date When this option is enabled, the time and date are also recorded during sampling operation. Auto Stop When this option is enabled, HMI stops recording when the maximum number of record data is reached. Retained (Non-Volatile) Using this option can enable HMI to save sampling data in SRAM. The capacity for saving history data of DOP-B series is 240 Kbytes. The battery of the SRAM provides power when the power is turned off.
(In some DOP-B series models, the user can save data in USB disk or CF card when the power is turned off and the capacity for saving alarm data depends on the capacity of the USB disk or CF card.) In addition, the file name can also be user-defined.