Mitsubishi — 3.14.1 Macro Type

Chapter 3 Creating and Editing Screens Table 3-14-1 Macro Command Table 3-276 Revision May, 2010 Macro Name Descriptions On Macro The user can use the On Macro for each specific button element (Bit). It is called the On Macro because the Macro is executed once upon the button element (Bit) changing from OFF to ON. Off Macro The user can use the Off Macro for each specific button element (Bit). It is called the Off Macro because the Macro is executed once upon the button element (Bit) changing from ON to OFF. Before Execute Macro The user can use the Before Execute Macro for all button elements and numeric / character entry element. One element has one Before Execute Macro.

After Execute Macro The user can use the After Execute Macro for all button elements and numeric / character entry element. One element has one After Execute Macro. Screen Open Macro The Screen Open Macro will be executed only ONCE when the user open a screen (or switch to a new screen) and the screen elements will not be displayed until after the Screen Open Macro has completed execution. Therefore, it is important that the user pay close attention when designing the Screen Open Macro to avoid infinite loops (programs that cannot be ended) as it may cause a system delay or even prevent executing the screen’s elements permanently.

Writing long macros is not recommended and should be avoided if at all possible. Pay close attention on using loops and make sure to test the Macro with on-line/off-line simulation before downloading to HMI to ensure expected performance and operation. Screen Close Macro The Screen Close Macro will be executed only ONCE when the user close the screen and no other macros will be executed until the Screen Close Macro is completed. Therefore, it is important that the user pay close attention when designing the Screen Close Macro to avoid infinite loops (programs that cannot be ended) as it may cause a system delay.

Screen Cycle Macro The macro will be executed continuously when the screen is open. Therefore, writing long macros is not recommended and should be avoided for this type of macro. Initial Macro There is only one Initial Macro in a program and it is executed just prior to the startup screen being displayed. This macro is very useful when setting initial values in the HMi or in a PLC.