Mitsubishi — 3.14.1.11 Sub-Macro

Chapter 3 Creating and Editing Screens $0 = 10 CALL 1($0 = 0) $1 = 1 Fig. 3-14-9 Execution process of Screen Open Macro When CALL 1 is executed, it means that Sub-Macro 1 is called and executed. After executing Sub-Macro, the system will continue to execute Sceen Open Macro till it ends. At this time, 0 = 0 and $1 = 1. NOTE When editing any macros, please pay close attention to the logicality of macro command, especially the usage of loop and program. If the user write an infinite loop (i.e. program cannot be ended) in the macro or write a program which will not be executed until some certain condition is satisfied, it may make HMI work abnormally.

Therefore, it is recommended that the user should use simulation function to verify the macro and check if HMI operation is correct or not after macro editing is completed. 3-288 Revision May, 2010