Mitsubishi — 3.14.3.9 Drawing

Chapter 3 Creating and Editing Screens and the Screen Cycle Macro is set as the user’s screen will look like the figure shown below.  CIRCLE (Draw an Ellipse) Equation RECTANGLE (Var1) Explanation This command is used to draw an ellipse on the screen. Var1 is the X-coordinate of the center of the ellipse Var1+1 is the Y-coordinate of the center of the ellipse Var1+2 is the length of the ellipse Var1+3 is the width of the ellipese Var1+4 is the color of the ellipse Remark  Var1 can be internal memory only. Example When the Screen Open Macro command is set as and the Screen Cycle Macro is set as 3-368 Revision May, 2010