Mitsubishi — 3.14.4 Macro Error Messages

Chapter 3 Creating and Editing Screens  Code – 107 There is RET in Macro This error message means that there is RET command in Macro. The RET command should be used for sub-macro to return program. But in Macro, it should use END not RET. HMI Macro Error Messages The users can read error messages by macro files. Once there is an error and the users execute a correct command before reading error messages, the error message will be overwritten. When executing each macro, each Macro error message will not be influenced by other macros.  Code – 10 GOTO Error This message means that there is a GOTO error in the macro.

 Code – 11 Stack Overflow This message means that the stack in the macro is full. This may be caused by using too many sub-macros or executing different macros at the same time. This message appears to help avoid insufficient memory.  Code – 12 Empty Sub-macro This is a CALL sub-macro error. The sub-macro that is called should not be an empty sub-macro. This message is to avoid unexpected errors.  Code – 13 Data Read Error This is a data read error. Sometimes this may be caused by a memory data error, but most of the time it is an external controller data read error.  Code – 14 Data Write Error This is a data write error.

Sometimes this may be caused by a memory data error, but most of the time it is an external controller data write error.  Code – 15 Divisor is 0 This error message means that the devisor is 0 when performing a division operation. Revision May, 2010 3-377