Chapter 4 Examples Click Options > 32bitss recipe , it can open 32bits Recipe Setup dialog box. In this example, two recipe tables are created, the write address is set to 1@D100 and the non-volatile area is set to HMI. In the 1st recipe table, set the Length to 5 and set the Group to 5. In the 2nd recipe table, set the Length to 5 and set the Group to 3. After pressing OK button, the user ’ s screen will look like the figure shown below. Then, click Save icon to complete the settings. Next, click Options > Configuration , select Control Block tab. To control the read and write operation of recipes, in this example, Control Address is set to 1@D0 and the Length is set to 8.
After complete the above settings, the user ’ s screen will look like the figure shown below. Revision May, 2010 4-7