Mitsubishi — 5.2 System Setting Menu

Chapter 5 System Menu 1.1 TP Delay – Set delay time of touch screen This option is used to set the sensitivity of the touch screen. This means that the user can speed it up or slow it down, based on user’s own preference. Touching RIGHT icon is to increase the delay time and slow it down. icon is to decrease the delay time and speed the screen sensitivity up. Touching LEFT 1.2 TP Force – Set pressing force of touch screen This option is used to set the pressing force of the touch screen. Touching LEFT icon is to reduce the pressing force to allow the user to enable the icon more easily. Touching RIGHT icon is to strengthen the pressing force to make the user not to enable the icon so easily.

1.3 Calibrate – Touch screen calibration This option is used to calibrate the touch screen to ensure accuracy of the touch areas. There are three points on the touch screen that the calibration is based around. When entering into the Calibrate function, the user will find three front sight icons on the top-left, bottom-right, and the center of the screen. Please touch these three icons in turn to calibrate the touch panel. Please note that if the user does not touch the on the center of these three calibration positions, a bigger position error may occur. Therefore, we recommend the user to use the specified touch pen to perform the calibration.

Please refer to the following figures for correct calibration steps. Step 1 Step 2 Step 3 Revision May, 2010 5-7 NOTE