Downloaded from https://www.everyspec.com MIL-STD-3001-4(AS) loading, such as clearance checks, servicing, and protection required, including all warnings and cautions, shall be included. Once loaded, any aircraft tie-down procedures required shall also be included. a. Folding and unfolding . b. Cockpit entry and safety check cock >. c. Towing tow >. d. Moving . e. Parking park >. f. Mooring moor >. g. Jacking jack >. h. Hoisting hoist >. i. Leveling level >. j. Protective covers procover >. k. Ground safety locks and pins safelock >. l. Carrier deck handling cardckhdl >. m. Preparation for catapulting prepcat >. n. Loading load >. o. Unloading unload >. p.
Arrested landing operation arrlndop >. q. Fueling fuel >. r. Defueling defuel >. 5.3.1.1.3.2 Handling ( engines, aeronautical equipment, airborne weapons/equipment, and support equipment ). Handling procedures for the end item, its sections, and components shall be provided, as applicable. Special handling procedures for transporting to and from ready-service stowage shall be included, emphasizing the use of handling equipment. For engines , coverage shall include handling instructions for engine removal from and installation in the shipping container and maintenance stand.
The coverage shall also include instructions for transferring an engine to and from a transport trailer and use of a standard Navy rail system. 5.3.1.1.4 Removal. a. Removal procedures shall be written for assemblies/components individually rather than included as part of the removal instructions for the next higher assembly. b. For major components such as engines , procedures shall be prepared for sequential dismantling of the engine in sections, modules or major assemblies.
Instructions shall indicate that care must be exercised to prevent the entrance of dirt and other foreign materials into the component, and, whenever practical, temporary covers shall be used to seal all openings in the dismantled component. c. For the transportation of aircraft, any components that require modification or removal to assist in the transportability shall be provided in the sequence of accomplishment. d. For the transportation of aircraft, procedures for the removal of any transport fixtures used in the transportation of the aircraft shall be included. 10