versely (horizontally or vertically) to cover and uncover the primer chamber opening. The block is operated manually, by suitably connected knob, handle, rod, or lever, and on opening actuates an extractor lever to withdraw the primer case. Per- cussion firing is effected by a firing pin carried in the block, actuated by a spring-impelled striker controlled by a sear and trigger mechanism man- ually cocked. For electric firing, insulated con- ductors and contacts are incorporated to provide an electrical path through the firing pin, also in- sulated, to the primer.
Firing is effected by closing the electrical circuit; hence, cocking of the striker is omitted,.and the firing pin is moved into contact with the primer without significant impact. In older designs, for use of combined electric and friction primers having a protruding, insulated, friction wire with bare terminal button, the striker is omitted from the design, and a firing leaf in- corporated. The leaf is a pivoted plate actuated by a lanyard and incorporates a slot and insulated clip to accept the covered wire and its bare terminal button, respectively. For friction ignition, a pull on the lanyard rotates the plate to pull the friction wire and so ignite the primer.
For electric firing a conductor is plugged into t,he insulated clip and connected to a power source through a circuit breaker. Ignition is effected by closing the circuit. Downloaded from https://www.everyspec.com anism is crank-connected to reduce the manual effort needed to swing the carrier, and the crank passes over center to secure the carrier in open position.
Various interlocks are provided to insure that the breechblock is rotated to the correct un- locked position before the carrier starts its opening swing, that the breechblock is secured against ro- tation until it is again carried into the recess to proper depth for meshing the locking threads, and that the firing mechanism can operate only while the breechblock is closed and locked. «*• .rh.«*.-iV Figure 3-77.
Bolt-type Breech Closure {Automatic Gun), Bolt Closing to Chamber the Cartridge In cannon of recent design, the interrupted- thread (plug) breechblock is mounted on the car- rier (see Figure 3-8), a combined housing and support member hinge-connected to exterior lugs of the breech ring in such a manner as to swing the breechblock rearward out of the breech. The type shown uses a horizontal swing. Some types employ a vertical swing. The breechblock support comprises a hollow cylindrical stud projecting from the carrier into the rear of the axial bore of the block.
A lateral shaft supported in the carrier carries a crank and crosshead at its inner end to rotate the breechblock to locked and unlocked po- sitions. An operating lever attached to the outer end of the shaft provides for manual rotation of the shaft, and for swinging the carrier to open and closed positions. In some designs separate handles are provided for swinging the carrier, and the operating lever is used only to lock and unlock the breechblock. A spring-loaded counterbalance mech- 3-5.2.2.1.4 Operating Mechanism Figure 3-72.
Bolt-type Breech Closure {Automatic Gun), Bolt Neoring Closed [Firing) Position 3-5.2.2.2 Bolt-type Breechblock Closures Bolt-type closures are widely used on small arms rifles, machine guns, and on automatic cannon of small bore diameter. Fixed ammunition is em- ployed. In this type (see Figures 3-11, 3-12 and 3-13), the opening and closing of the breech is effected principally through rearward and forward