US Army Materiel Command AMCP 706-250 — Engineering Design Handbook: Guns Series — Guns-General

Downloaded from https://www.everyspec.com the magazine, that provides power operation for both magazine and rammer tray mechanisms. These principal units are all mounted on the nonrecoiling gun cradle. General construction and functioning as as follows: (c) Tray and Rammer The tray is a flat-sided trough with the bottom formed by an endless chain running over sprockets at the front and rear ends. The chain carries sup- porting blocks for the cartridge and a head for pushing the base of the case.

Chain drive is through the rear sprocket, which is mounted on a transverse shaft connected, by gear train, gear sector and connecting rod, to the cam-actuated oscillating arm on the left side of the transmission case. The tray is supported by the sprocket shafts in journals at the outer ends of two parallel arms pivoted on the side frame of the loader-rammer, below the horizontal section of the magazine.

When the supporting arms extend vertically below their pivots, the tray is aligned with the gun bore in position for ramming action by the chain; when the arms are rotated upward 180 degrees, the tray is thereby lifted to the exit of the horizontal (cross feed) section of the'magazine, where it comes to rest embracing the next round to be rammed. Ro- tation of the rams from upper to lower position and return is effected through a spur gear on the pivot shaft of each arm, both being meshed with (a) Transmission The stub shaft driven by the motor rotates, through helical gears, a longitudinal shaft incor- porating a limited-torque safety clutch and a worm.

The worm drives a worm gear incorporating a self- releasing pin clutch carried on a transverse cam shaft. The clutch, when engaged, drives the cam shaft one complete revolution, then disengages it- self. Plungers linked to the gun breech mechanism prevent re-engagement until the gun has completed its cycle and is in battery, breech open, ready for the next round.

The cam shaft carries three cams; one oscillates an arm on the right exterior of the case, to actuate the lowering and raising of the rammer tray; a second oscillates an arm on the left exterior of the case to drive the rammer chain; and the third oscillates a gear sector that drives the groups of pawls employed to feed rounds from the magazine into the rammer tray. (b) Magazine A cylindrical skeleton frame, with axis parallel to the gun bore, is mounted on each side of the gun cradle. An axial shaft in each cylinder car- ries front and rear star wheels that support the rounds with their axes parallel to the gun bore.

Rotation of the wheels feeds the rounds from the lower side of the cylinder into a horizontal frame that guides the rounds laterally to the centrally located exit into the rammer tray. Feeding is accomplished by laterally reciprocating racks car- rying spring loaded pawls, the racks sliding in the horizontal frame and driven by gear train from the cam-operated gear sector in the transmission box. Spring-loaded pawls prevent reverse travel of the rounds. A manual lever actuates a shifting device in the transmission to effect feeding from the right or left half of the magazine, as desired. When one side is emptied, the shift is effected automatically to feed from the opposite side.

Rounds are inserted into the cylindrical sections of the magazine by removal of the top half of the cylindrical frames, or singly by unlocking the cir- cular retainer plate at the rear of the cylinder, and rotating the plate until its loading aperture is aligned with an empty notch in the star wheel. Figuro 3-23. Automatic loader for Clip-hold Cartridges. iloft-Roar View). 3—23