Downloaded from https://www.everyspec.com for chambering by the operation of closing the breech, has been superseded by mechanical methods. Current small arms guns for uses in which rapidity of fire is of no particular advantage (signal pistols, for instance) are designed for manual'insertion of the round into the chamber and feeding, in the sense indicated above, is not an individual action in operation of the gun. The multiple chambers of a revolver are also filled by hand, either indi- vidually or in groups of three held by a thin flat curved clip, or charger, which supports the car- tridges parallel and properly spaced to enter three adjacent chambers of the revolver cylinder.
In the closed lower end is seated a coiled wire spring capped by a follower plate. Above the follower plate one column of cartridges is inserted, depressing the follower and compressing the spring. The mouth of the magazine, at the upper end, has inwardly curved lips on the sides to prevent up- ward ejection of the top cartridge, and is cut away at front and rear to permit the lower front face of the slide of the pistol, in connterrecoil, to strike the upper portion of the cartridge base and push the cartridge forward axially out of the magazine mouth, up a short ramp and into the chamber.
When, on firing, the slide again recoils to clear the magazine mouth, the spring and follower raise the cartridge stack to place the top remaining cartridge in the magazine mouth, ready for chambering. A variation of this type of magazine, for automatic rifles, uses two columns of cartridges, staggered and feeding alternately into the mouth of the magarine, 3-8.2.2 Magazine Feeding Methods One means of continuous supply of cartridges to a rapid-firing weapon is the magazine. This is essentially a container, with an outlet so located or with such post-outlet mechanism as to place successive cartridges in position for chambering.
In various forms, it may be incorporated in the gun structure, may consist of a unit affixed to the gun, or it may be a unit for insertion, filled, in a receptacle in the gun and removal when empty. Energy for movement of cartridges through the outlet and to pre-chambering position may be pro- vided by the gun, by an external power source, or by a spring within the magazine, compressed in the process of charging the magazine. Examples of several arrangements follow: 3-8.2.2.2 Long Type Magazine Magazines used in various automatic or semi- automatic rifles operate similarly to the short maga- zine but differ in having a greater length and re- sulting greater cartridge capacity.
Variations in- clude an arc shape for more compact containment of tapered cartridges or a'drum enclosing a spiral or helical arrangement of cartridges, with a spiral spring actuating the follower. For a limited number of cartridges the tubular magazine is usually an integral part of the gun, positioned below and substantially parallel to the. barrel. The cartridges, axially aligned, base to nose with noses forward, are fed by a compressed, spring to emerge endwise from the tube into the lower part of the receiver. On emergence, the car- tridge is below and behind the chamber, approxi- mately parallel to it and resting on a carrier lever pivoted at the upper rear of the receiver.
As the bolt reaches rear position, the carrier is actuated to swing upward and lift the cartridge sufficiently to be engaged by the bolt and pushed into the cham- ber as the bolt moves forward. The closing move- ment of the bolt releases the carrier, which is re- turned to its lower position by spring action for reception of the next cartridge released from the magazine. 3.8.2.2.3 Tubular Magazine Figur» 3-24.
Automatic Pistol, Sectioned, Cartridge in Mouth of Magazin» 3-8.2.2.1 Short Type Magazine The magazine used in the standard automatic pistol (Figure 3-24) is a relatively short flat-sided metal tube that is loaded, then inserted upwardly into the handle of the pistol and latched in position. 3—25