Downloaded from https://www.everyspec.com front edge of the band is pushed into the forcing cone. 4-4.2.6 Centering Slope The centering slope is a tapered section imme- diately to the rear of the band rear slope (artillery) or case clearance shoulder (small arms). It serves to guide the projectile, cartridge case, or cartridge being inserted toward concentricity with the bore. In guns using conventional cartridge cases, the taper is slight, and the section, closely encircling the neck of the case, provides the surface agafhst which the mouth of the case is expanded by propel- lant pressure to seal against rearward escape of gases.
4-4.2.4 Case Clearance Shoulder This feature, appearing in some small arms, com- prises an increase in diameter immediately back of the bullet seat to clear the mouth of a cartridge case crimped onto the bullet as the mouth expands to release the bullet. For some noncrimped car- tridges, the shoulder forms a seat for the cartridge mouth, and stops the case at the correct depth of insertion when the cartridge is chambered. 4-4.2.5 Band Rear Slope 4-4.2.7 Chamber Front Slope This tapered section accomplishes the reduction from the main cavity of the chamber to a suitable size for the centering slope.
For some small arms cartridges, this slope forms a seat for the shoulder of the case, and so stops the cartridge at the proper chambered position. This is a tapered section used in separate loading cannon, immediately back of the band cylinder. It serves to guide the rotating band of the projec- tile being inserted to the central position required for entry into the band cylinder.