— AMCP 706-286 — Engineering Design Handbook (1963)

Downloaded from https://www.everyspec.com STRUCTURES pressive tress in the presence of the pr.- scribed internal pressure p. Similarly, R, is the ratio of the si-taring stress caused by the 0 torque of the trifle loading to the critical shearing stress of torsion in the presence of E A the prescribed internal pressure p. ' . A circular cylindrical shell subjected simultaneously to torsion and internal pres- sure does not buckle if the following inequal- CE 5 s (ity is stisfied:

"- where R, is the ratio of the shearing stress of the combined loading to the critical shear- j ing stress under pu.e torsion while R., is the ratio of the internal pressure p to the critical pressure of hydrostatic loading (both pre-s- sures are coasiered positive in this context). Figure 3-3. Determination of Tangent Modulus and Secant Modulus from Stress-Strain Curve 3-4.9. Inelastic Buckling. When the stresses -E UCKLING OF THIN SPHERICAL at which buckling takes place according to SHELLS the formulas given are higher than the limit The critical compressive stress in a uni- of elasticity of the material, the theories formly compressed thin-walled spherical .

underlying the formulas are not valid. They shell is must be modified in order to arrive at results = 0.2E(h/R) (3- 35) useful in engineering applications. As the The correspondiog value of the critical pres- theory of inelastic behavior is in lesser agree- sure is ment with test results than the theory pl elastic behavior, plastic buckling formulas (3 must be used with some degree of caution. 3-6. THERMAL STRESSES In the calculation of buckling stressas greater than the elastic limit, two moduli 3-6.1. Straight Bar. If a straight bar were are of importance in addition to Young's heated from a uniform initial temperature Modulus E.

One is the tangent modulus Et T, to a uniform final temperature T, it would defined as the rate 6f change of the stress expand and its initial length L would increase with strain at the particular value of the by the amount stress; and the other the secant modulus E. AL = a(T - T,)L (3 37) which is the ratio of the particular value of where a is the coefficient of thermal expan- the stress to the c,,)rresponding value of the sion, usually r, asured in inchies per inch per strain (see Figure 3-3). Both E, and E. are degree Fahrenheit. equal to E when the stress-strain relation is If, however, the bar is held between insu- represented by Hooke's straight line.

In the lated walls as shown in Figure 3-4, the insu- case of plastic bucliing, E in the formulas lated walls prevent this 'expansion completely must be replaced s ome combination of E, by setting up thermal stresses of a magnitude and E4 ; in a first approximation one may use a= - E(T - T) (3 38) E. inste.,d of E. For more accurate results where E is Young's Modulus and the nega- recourse should be had to the literature."."- tive sign indicates that the thermal stress is 46 41 1 L