US Army Materiel Command AMCP 706-117 — Environmental Series, Part Three: Induced Environmental Factors

Downloaded from https://www.everyspec.com "AMCP 706-117 PREFACE This handbook, •hdued ER/onwatu Fctors, is the third in a series on the nature and effeet& of the environmental phenomena. As the title implies, the handbook addresses a set of induced environmental facto. which, for the paopose of this lexcomprIse: a. Atmospheric Pollutants b. Sand and Dust c. Vibration d. Shock a. Acceleration f. Acoustics S. Electromagnetic Radiation h. Nudear Radiation. Them particular factor were chosen a best representing the needs of the design engineer. It is recognized that this set is arbitrary and that natural fcrces contribute, sometimes In a major way, to these environmental paumeters.

The information is organized as follows: a. Description of the factor, its measurement, and Its distribution b. Description of the effects of the factor on materiel and the procedures for design so a to avoid or reduce adverse effects. c. Enumeration of the testing and simulation procedures that assure adequate design.... Thus, the design engineer is provided with a body of practical information that will enable him to design materiel so that its performance during use is not affected seriously by the environment. It Is impractical to acknowledge the assistance of each individual or organiution which oontributed to the preparation of the handbooks.

Appreciation, however, Is extended to the following organizations and through them to the Individuals concerned: a. Ftankford Arsenal b. US Army Engineer Topographic Laboratories c. US Army Tank.Automotive Command d. US Army Transportation Engineering Agency e. Atmospheric Sciences Laboratory, US Army Electronics Command. The handbook was prepared by the Research Triangle Institute, Research Triange Park, NC--for the Engineering Handbook Office of Duke University, prime contractor to the US Army Materiel Command-under the general direction of Dr. Robert M. Burger. Technical guidance and coordination were provided by a committee under the direction of Mr. Richard C.

Navadn, Hq, US Amy Materiel Command. The Engineering Design Handbooks fail into two basic categories, those approved for relase and sale, and those clashified for security reasons. The US Army Materiel Com- mand policy Is to release these Engineering Design Handbooks in accordance with current DOD Directive 7230.7, dated 18 September 1973. All unclassified Handbooks can be obtained from the National Technical Information Service (NTIS). Procedures for acquir- Ilg thes Handbooks follow: a. All Department of Army activities having need for the Handbooks must submit their request on an official requisition form (DA Form 17, dated Jan 70) directly to: Commander Lettarkenny Army Depot ATTN:

AMXLE-ATD Chambenbufg, PA 17201 xix