US Army Materiel Command AMCP 706-117 — Environmental Series, Part Three: Induced Environmental Factors

Downloaded from https://www.everyspec.com , .1M.1 AMIP 70&I117 The COH unit can be defined a the quantity of ment that alters the electrical capacitance of the detec- S| panktulaie matter thatt produce an optical density of' tion circuitry. 0.01 when measred by light transmittance in the re- The measuring range of NDIR carbon monoxide lion of 375 to 450 run. The transmittance of a clean analyzers is normally 0 to 50 or 0 to 100 ppm. Filter filter is used as a reference and Is met at 0.0 density 100 cells are used to minimize interferences from carbon pecent transmittance). The light transmitted through monoxide and water vapor. the filter tape is expremed as follows:

(4) Photochemical oxidants (ozome). The reference method for measurement of ozone is the chemilumins- cent reaction between ozone and ethylene. This method Optical density * log (lol1) (2-20) is diecussed in the chapter on ozone (Chap. 12, Part Two). wher (5) Hydrocarbons (nonmethane). The referenes - - method for measuring hydrocarbons corrected for meth- 4 - initial tansmittance ofp liht ane Is the gas chromatographlc-flame ionliatlon through dean spot detection (GC.FID) method. Fig. 2-32 Is a typical flow I - ttansmittaer of light through dagram for a OC-FID hydrocarbon monitor. solid spot. Measured volume of air an delivered aemleontinu.

For estimation purposes, 1 COH unit equal approxi- oudy (4 to 12 times per hour) to the hydrogen flame mately 125 1g m-'. Ionization detector to measure Its total hydroostbon The preceding description is general and applies to (THC) content. An aliquot of the same air sample Is all makes of tape samplars. Deluxe models are available Introduced into the stripper column that removes water, which have direct readout of percent transmittance or carbon dioxide, and hydrocarbons other than methme. COH's on recorder paper, direct printout on tape, Methane and carbon monoxide are paseed quantitatively telemetering hardware, or computer interfacing.

to the go chronmatographic column where they ar The optimal range for optical density memurements separated. The methane Is passed unchanged through a is from 0.05 to 0.3. The sampling interval usually is catalytic reduction tube Into the flame Ionization detec- adjusted so that optical density falls in this range. tor. Hydrocarbon concentrations corrected for methane (3) Carbon monoxide The nondispersive infrared then an determined by subtracting the methane value (NDIR) method is the reference method for measuring from the THC value. The method Is used for semicon. carbon monoxide. A typical analyzer (as shown in Fig.

tinuous operation with the capability of performing one 2-31) consists of a sampling system, two infrared analyals every 5 rmin. sources, sample and reference gas cells, detector, con- Instruments such as the Beckman 6800 (see Table trol unit and amplifier, and recorder. The reference cell 2-18) using the OC-FID method measure carbon contains a noninfrued-absorblng gas while the sample monoxide and methane as well as total hydrocarbons. cell is continuously flushed with the sample atmos- (6) Nitrogen dioxide. The 24-hr sampling method, phere.

The detector consists of a gas cell having two often referred to as the Jacoba-Hochheiser method, was compartments (both filled with carbon monoxide un- published by EPA as the reference method for the der pressure) separated by a diaphragnm whose move- measurement of nitrogen dioxide in ambient air. This ment changes the electrical capacitance in an external method is applicable to collection of 24-hr integrated circuit and, ultimately, an amplif-d elactrical signal samples in the field with subsequent analysis in the suitable for input to a servo-type recorder. laboratory.

During operation the optical chopper intermittently Nitrogen dioxide is collected by bubbling air through expoem the reference and sample cells to the infrared a sodium hydroxide solution to form a stable solution sources. A constant amount of infrared energy passes of sodium nitrite.

The nitrite Ion produced during sam- through the reference cell to one compartment of the pling is determined colorimetrically by reactin the detector cell while a varying amount, inversely propor, exposed absorbing reagent with phosphoric acid, aul- tional to the carbon-monoxide concentration in the fanilamide, and N-l.naphthylethylenediamine dihydro- sample cell, reaches the other detector cell compert- chloride. This method is capable of measuring nitrogen ment. The unequal quantities of infrared energy reach- dioxide concentrations ranging from 0.01 to 0.4 ppm.

ing the two compartments of the detector cell cause Much criticism has been directed at the extremely low unequal expansion of the detector gas. This unequal collection efficiency and the Inability to automate the expansion moves the detector cell diaphragm, a move- system. The chemiluminsecent reaction between nitric 247