Hantek — DPO7000 UserManual

Protocol EN 4. Data: Click on the Data menu tab to set the data values by turning the multifunction knob V0 or by the pop-up numeric keypad directly. 5. Send rate: Click the Send rate menu tab and select the desired send rate from the drop-down menu or select Custom send rate. 6. AddressWide: Click the AddressWide menu tab, and select the address bit width: 7bits, 10bits from the drop-down menu. 7. DataBits: Click the DataBits menu tab, and select the data bits as follows: 1 Byte, 2 Byte, 3 Byte, 4 Byte, 5 Byte, 6 Byte, 7 Byte, 8 Byte from the drop-down menu. 8. Trigger Mode: Click the Trigger Mode menu tab and select Auto or Manual. 9. OverTime:

Click on the OverTime menu tab to set the interval value by turning the multifunction knob V0 or directly set the interval value by popping up the numeric keypad. 10. Burst: When the trigger mode is set to manual trigger, click the Burst menu tab to manually trigger once. Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 169