Quik key EN setting function menu. 1. :Press the menu label, and the screen will automatically display the complete single cycle of the signal, while measuring the cycle and frequency of the currently displayed complete single cycle waveform. The measurement results are displayed at the bottom of the screen. 2. :Press the menu label and the screen will automatically display multiple cycles of the signal, while measuring the cycle and frequency of the currently displayed multi cycle waveform. The measurement results are displayed at the bottom of the screen. 3.
:Press the menu label and the screen will automatically display a rising edge of the signal, while measuring the rise time of the current rising edge. The measurement results are displayed at the bottom of the screen. 4. : Press the menu label and the screen will automatically display a falling edge of the signal, while measuring the falling time of the current falling edge. The measurement results are displayed at the bottom of the screen. 5. :Press the menu label to return to the menu displayed when the user last set it. 20.2 Default Setup Press the [Default Setup] button, and the oscilloscope will display waveforms for four channels.
The following table provides settings for changing options, buttons, and controls under default settings. Table 20.2 Default Setup DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 206 Horizontal Horizontal Time Base 1us Horizontal Position 0s Delayed Sweep Off Timebase Mode YT Fine Off Horizontal Expansion Center Vertical Vertical Scale 1V Vertical Offset CH1: 3V, CH2: 1V, CH3: -1V, CH4: -3V CH1/CH2/CH3/CH4 CH1-CH4 On