Hantek — DPO7000 UserManual

Quick start EN 4.7 Rear Panel Overview 1. Handle: Users can vertically pull up the handle for easy access to the oscilloscope; When not in use, press down on the handle. 2. LAN interface: This interface is used to connect the oscilloscope to the network. 3. USB VIEW interface: This interface is used to connect the oscilloscope to the computer, and users can send SCPI commands or customize programming to control the oscilloscope through the upper computer software. 4. Reference clock: The use of a reference clock can provide a more accurate sampling clock signal for the oscilloscope, and can also be used to synchronize the clocks of two or more oscilloscopes. 5. EXT input:

This interface is used to input external trigger signals to the oscilloscope. 6. G1 signal source output terminal: This interface outputs the waveform set by the signal generator. 7. Trigger output and pass/fail: Trigger output: When the oscilloscope generates a trigger, a signal reflecting the current capture rate of the oscilloscope can be output through this interface. The signal can be connected to the waveform display device to measure the frequency of the signal, Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 25 6 G1 signal source output terminal 7 Trigger output and pass/fail 8 HDMI 9 RS232/485 10 AC Power Cord Connector