mean-well DRS - 240 / 480 Series — Mean Well DRS 240/480 Series Power Supply User Manual PDF

5 The master adjusts the output voltage of the unit with the address 03 to 30V. The master reads the operation setting from the unit with the address 3 The following steps will describe how to set the DRS-240-48 to Parameters 0xB80B Command Code: 0X0020(Vout_Set) →0x0020(Low)+0x00(High) Note: Conversion factor for VOUT_SET 0.01 is so =3000 30V Parameters Data:0x01 ON, means that the unit with the address 03 is operating. 0x01 0.01 56V(for -240-48, the output range is 40V~56V) DRS Command Code Parameters: 30V →3000V →0xB8(Low)+0x0B(High) Command Code The unit with the address 03 returns the data below: Command Code 0x2000 0x 000 0 0x 000 0 1. Confirm the address of the DRS-240-48 5. .

4 5 CANBus communication examples 5. . . Sending command 4 5 1 DLC(data length) DLC(data length) DLC(data length) 58 5. . . Re ding data or status 4 5 2 a 0x04 0x02 0x03 5. . Practical operation 4 5.3 4 2 3 1 6 8 5 7 CN12 CAN ID 0xC0103 CAN ID 0xC0103 CAN ID 0xC0 03 0 Diagram of the output voltage over time when the batteries are not Diagram of the output voltage over time when the batteries are Bit 0:7 Reserved: Currently not in use, retain (default is 0) V 1 The voltage of the batteries 5s t 5s t Note: Not support settings display with “0” 57 V V V o= rated V V V o= rated connected. 130%V o 100%V o 70%V o 0 connected.

130%V o 70%V o 100%V o 0 High byte: 5 CAN ID DLC(data length) Command Code Parameters 0xC0103 0x04 0x2000 0xB80B CAN ID DLC(data length) Command Code 0xC0103 0x02 0x 0000 CAN ID DLC(data length) Command Code Parameters 0xC00 03 0x03 0x 0000 0x01