6 Status Possible cause Suggestion for fault correction Check connection, specification of battery, or change battery Choose a proper cable for usage Double check the characteristic of battery Power supply has built-in MOSFET to achieve reverse polarity s protection. When the faulty condition removed, power supply Check connection or change new battery Make sure PIN7&8 of CN12 well-connected Cool down temperature and re-power on. Check specification of battery Eliminate abnormal condition and re-power on. 2. Please contact MEAN WELL s distributor if above ' Check load condition and re-power on. Change new batteries Note:1. Refer to chapter 4.3 for LED indicator.
faulty condition is not removable. will automatically recover without damage. Battery back-up failure Un-connected, low voltage battery Button: low battery voltage/reverse connection Battery start failure Battery discharging peak power over time(Red LED flashes at 4 pulses) Over temperature (Red LED flashes at 6 pulses) Small cross-section of cable 6 1.5 . Reverse polarity protection CN12: bad connection Over voltage (Red LED flashes at 2 pulses) Short circuit (Red LED flashes at 5 pulses) Aged battery or malfunction Wrong charging curve 72 6 2 .
Failure orrection c Battery can not be fully charged Automatically shut down under suitable AC input When the voltage of battery is too low, power supply will shut down. When output current reaches the protection criteria, power supply will limit its output constant current, and shut down as When the internal temperature of power supply is too high, power supply will shut down for protection and turn on it will In charging mode, when the internal temperature of power supply is too high, power supply will automatically decrease output power according to the derating curve, chapter 2.5.
If the temperature is still too high over limitation, power supply When output voltage over specification, over voltage protection will be activated, and power supply shuts down. When the faulty will shut down and recover once the temperature cool down. condition removed, re-power on to remove the protection. Note: If battery under-voltage protection is triggered by force for protection 5 seconds. Re-power on to recover. after automatically if the temperature . is back to normal range 6. Protection and Failure Correction Model Protection limitation 6 1.4 . Battery under voltage protection 12V 10 5 . ±0.3V 24V 20 9 . ±0.5V 36V 31 3±0.7V . 48V 41 8±1.0V . button, please refer to 5.7.3. 6 1.2 .
Over temperature protection 6 1.3 . Output over voltage protection 71 6 1.1 . Over load protection 6 1 . Protections 6