Administrator Information > Advanced Security Settings > Solving Problems for Advanced Security Solving Problems for Advanced Security Hints to Solving Problems ❏ Checking the error message When trouble has occurred, first check whether there are any messages on the driver screen. If you have the notification email set when the events occur, you can promptly learn the status. ❏ Checking the communication status Check the communication status of server computer or client computer by using the command such as ping and ipconfig. ❏ Connection test For checking the connection between the scanner to the mail server, perform the connection test from the scanner.
Also, check the connection from the client computer to the server to check the communication status. ❏ Initializing the settings If the settings and communication status show no problem, the problems may be solved by disabling or initializing the network settings of the scanner, and then setting up again. Related Information & “Buttons” on page 21 & “Receiving Email Notifications When Events Occur” on page 191 Cannot Access Web Config The IP address is not assigned to the scanner. Solutions A valid IP address may not be assigned to the scanner. Set a valid IP address using Epson Scan 2 Utility. You can confirm the current setting information from Epson Scan 2 Utility.
& “Checking the Scanner's IP Address” on page 68 Web browser does not support the Encryption Strength for SSL/TLS. Solutions SSL/TLS has the Encryption Strength. You can open Web Config by using a web browser that supports bulk encryptions as indicated below. Check you are using the a supported browser. ❏ 80bit: AES256/AES128/3DES ❏ 112bit: AES256/AES128/3DES ❏ 128bit: AES256/AES128 ❏ 192bit: AES256 ❏ 256bit: AES256 219