Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set API 01 Operands: S : The destination pointer P of the call subroutine. Explanations: 1. When the CALL instruction is active it forces the program to run the subroutine associated with the called pointer. 2. A CALL instruction must be used in conjunction with FEND (API 06) and SRET (API 02) instructions. 3. The program jumps to the subroutine pointer (located after an FEND instruction) and processes the contents until an SRET instruction is encountered. This forces the program flow back to the line of ladder immediately following the original CALL instruction. Points to note: 1. Subroutines must be placed after FEND instruction. 2.

Subroutines must end with SRET instruction. 3. CALL pointers and CJ instruction pointers are not allowed to coincide. 4. CALL instructions can call the same CALL subroutine any number of times. 5. Subroutines can be nested 5 levels including the initial CALL instruction. (If entering the six levels, the subroutine won’t be executed.) 3-45 Mnemonic Operands Function Controllers SA2 ES2/EX2 SS2 SX2 SE CALL P Call Subroutine Controllers ES2/EX2 SS2 SA2 SX2 SE OP Valid Range Program Steps P0~P255 CALL, CALLP: 3 steps PULSE 16-bit 32-bit SA2 SA2 ES2/EX2 SS2 SA2 SE SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 SE SE