3. Instruction Set API 64 Operands: D : Device No. for storing the ON time of the input n : setting of multiple ( n : K0~K2) Explanations: 1. The ON time of the external button switch is measured and stored in D + 1 (unit: 100ms). Value in D + 1 is multiplied with a multiple specified by n and stored in D (unit: sec). 2. When n = K0, the value in D + 1 (unit: 100ms) is multiplied with 1 and converted to D (unit: sec). When n = K1, the value in D + 1 (unit: 100ms) is multiplied with 10 and converted to D (unit: sec). When n = K2, the value in D + 1 (unit: 100ms) is multiplied with 100 and converted to D (unit: sec). 3. TTMR instruction can be used max 8 times in a program. Program Example 1:
1. The duration that input X0 is pressed (ON duration of X0) will be stored in D1. The value in D1, multiplied by a multiple specified by n , is then moved to D0. In this case, the button switch can 2. When X0 = OFF, the content of D1 will be reset but the content of D0 remains. be used to adjust the set value of a timer. X0 T T On time (sec) On time (sec) 3. If ON duration of X0 is T sec, the relation between D0, D1 and n are shown as the table below. 3-171 Mnemonic Operands Function Controllers TTMR Teaching Timer ES2/EX2 SS2 SA2 SX2 SE Type OP Bit Devices Word devices Program Steps X Y M S K H K nX KnY KnM KnS T C D E F TTMR:
5 steps D * n * * PULSE 16-bit 32-bit SA2 SA2 SA2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 SE SE SE TTMR D0 K0 X0 D1 D1 D0 D0 n D0 (unit: sec) D1 (unit: 100 ms) K0 T (sec) ×1 D1 = D0×10 K1 T (sec) ×10 D1 = D0 K2 T (sec) ×100 D1 = D0/10