Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming Operands: S : Start device for the source data m 1 : Groups of data to be sorted ( m 1 =1~32) m 2 : Number of columns in the table ( m 2 =1~6) D : Start device for the sorted data n : The No. of column to be sorted. ( n =1~ m2 ) Explanations: 1. The sorted data is stored in the m 1 Ч m 2 registers starting from the device designated in D . Therefore, if S and D designate the same register, the sorted results will be the same. 2. It is better that the rightmost number of the device number of the register specified by S is 0. 3. SORT instruction is completed after m 1 times of scan.

Once the SORT instruction is completed, the Flag M1029 (Execution completed flag) = ON. 4. There is no limitation on the times of using this instruction in the program. However, only one 5. The function of sorting one-dimensional data is added. If m 1 is 1, and m 2 is 1, the function will be instruction can be executed at a time enabled, and the operand n represents the number of data ( n =1~32). The data in n devices starting from the operand S are sorted. The sort result is stored in the devices starting from the operand D . It takes one scan cycle for the data to be sorted. After the data is sorted, M1029 will be On. This function supports SS2 V3.0/SA2 V2.6/SX2 V2.4/ES2/EX2/ES2-C V3.2.

Program Example: When X0 = ON, the sorting process starts. When the sorting is completed, M1029 will be ON. DO NOT change the data to be sorted during the execution of the instruction. If the sorting needs to be executed again, turn X0 from OFF to ON again. X0 3-196 API Mnemonic Operands Function Controllers 69 D SORT Data sort ES2/EX2 SS2 SA2 SX2 SE Type OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F SORT: 11 steps DSORT: 21 steps S * m 1 * * m 2 * * D * n * * * PULSE 16-bit 32-bit ES2/EX2 S SS2 A2 SE SX2 SA2 SA2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 SE SE SORT D0 K5 K5 D50 D100