3. Instruction Set 75 Operands: S : Start device for key input (occupies 4 consecutive devices) D 1 : Device storing the value to be displayed in 7-segment display D 2 : Output device for 7-segment display n : Configuration setting of output signal ( n = 0~3). Please refer to explanations of SEGL instruction for the n usage. Explanations: 1. ARWS instruction displays the value set in device D 1 on a set of 4-digit 7 segment display. PLC automatically converts the decimal value in D 1 to BCD format for displaying on the 7 segment display. Each digit of the display can be modified by changing the value in D 1 through the operation of the arrow switch. 2.
Number of D 2 only can be specified as a multiple of 10, e.g. Y0, Y10, Y20…etc. 3. Output points designated by this instruction should be transistor output. 4. When using this instruction, please fix the scan time, or place this instruction in the timer interruption subroutine (I610/I699, I710/I799). 5. There is no limitation on the times of using this instruction in the program, but only one instruction is allowed to be executed at a time. Program Example: 1. When the instruction is executed, X20 is defined as the Minus key, X21 is defined as the Add key, X22 is defined as the Right key and X23 is defined as the Left key. The keys are used to modify the set values (range:
0 ~ 9,999) stored in D20.. 2. When X0 = ON, digit 10 3 will be the valid digit for setup. When Left key is pressed, the valid digit will shift as the following sequence: 10 3 →10 0 →10 1 →10 2 →10 3 →10 0 . 3. When Right key is pressed, the valid digit will shift as the following sequence: 10 3 →10 2 →10 1 →10 0 →10 3 →10 2 . Besides, the digit indicators (LED, Y24 to Y27) will be ON for indicating the position of the valid digit during shift operation. 4. When Add key is pressed, the content in the valid digit will change as 0 → 1 → 2 … → 8 → 9 → 0 →1. When Minus key is pressed, the content in the valid digit will change as 0 → 9 → 8 … → 1 → 0 → 9.
The changed value will also be displayed in the 7-segment display. X0 K0 3-211 Mnemonic Operands Function Controllers ARWS Arrow switch ES2/EX2 SS2 SA2 SX2 SE Type OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F ARWS: 9 steps S * * * * D 1 * * * * * D 2 * n * * PULSE 16-bit 32-bit SA2 SA2 SA2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 SE SE SE ARWS X20 D20 Y20