DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 5. If an SE series MPU is connected to a right-side special module, and M1183 is Off, the range of data registers can be used. Every special module connected to an SE series MPU occupies ten data registers. 6. If an SE series MPU is connected to a left-side special module, and M1182 is Off, the range of data registers can be used. Every special module connected to an SE series MPU occupies ten data registers.
2.5 Status and Allocation of Latched Memory 2-10 Clear all Clear all Memory Power non-latched Factory STOP=>RUN RUN=>STOP latched areas type OFF=>ON areas setting (M1032=ON) (M1031=ON) Clear Unchanged When M1033=OFF, clear Clear Unchanged 0 Non- latched When M1033=ON, No change Latched Unchanged Unchanged Clear 0 Special Initial Unchanged Unchanged Initial setting M, Special D, Index register File Unchanged HFFFF register General Latched Special auxiliary relay M0~M511 M768~M999 M2000~M2047 M512~M999 M2048~M4095 M1000~M1999 M Auxiliary relay Not latched Latched Some are latched and can’t be changed.
100 ms 100 ms 1 ms 10 ms 10ms 1 ms 100 ms T0 ~T126 T128~T183 T184~T199 T127 T200~T239 T240~T245 T246~T249 T250~ T255 T Timer M1028=1,T64~ T126:10ms For subroutine - M1038=1,T200~T245:
1ms - non-latched non-latched Accumulative non-latched 16-bit count up 32-bit count up/down 32-bit high- speed count up/down C Counter C0~C111 C128~C199 C112~C127 C200~C223 C224~C232 C233~C254 Non-latched Latched Non-latched Latched Latched Initial Zero return Latched General Step alarm S S0~S9 S10~S19 S20~S127 S128~S911 S912~S1023 Step relay Latched Non-latched Latched General Latched Special register For AIO D0~D407 D600~D999 D3920~D11999 D408~D599 D2000~D3919 D1000~D1999 D9800~D999 9 D Register Non-latched Latched Some are latched, and can’t be changed Non-latched