Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 2. Registers for setting ramp up/down time and start/end frequency:  Output Y0: Sample time of ramp-up Pulse output frequency Ramp-up slope Start freq. End freq. Y0(D1340) Y0 (D1340) Min: 6Hz Min: 6Hz Numbers of output pulses Ramp down time Ramp up time Default: 100ms Current position Default: 100ms Y0(D1343) Y0(D1343)  This instruction can be used many times in user program, but only one instruction will be activated at a time. For example, if Y0 is currently activated, other instructions use Y0 won’t be executed. Therefore, instructions first activated will be first executed.

 After activating the instruction, all parameters cannot be modified unless instruction is OFF. 3. Associated Flags: 3-408 M1029: CH0 (Y0, Y1) pulse output execution completed. M1102: CH1 (Y2, Y3) pulse output execution completed M1078: CH0 (Y0, Y1) pulse output pause (immediate) M1104: CH1 (Y2, Y3) pulse output pause (immediate) M1108: CH0 (Y0, Y1) pulse output pause (ramp down). M1110: CH1 (Y2, Y3) pulse output pause (ramp down) M1119: Enabling the DDRVI/DDRVA two speed output function M1156: Enabling the mask and alignment mark function on I400/I401(X4) corresponding to Y0. M1158: Enabling the mask and alignment mark function on I600/I601(X6) corresponding to Y2. M1305:

Reverse Y1 pulse output direction in high speed pulse output instructions M1306: Reverse Y3 pulse output direction in high speed pulse output instructions M1347: Auto-reset Y0 when high speed pulse output completed M1524: Auto-reset Y2 when high speed pulse output completed M1534: Enable ramp-down time setting on Y0. Has to be used with D1348 M1535: Enable ramp-down time setting on Y2. Has to be used with D1349.