3. Instruction Set Operands: S : Set-point value for driving the output device (Unit: hour) D 1 : Current time being measured D 2 : Output device Explanations: 1. HOUR instruction drives the output device D 2 when the measured current time D 1 reaches the set-point value in S . 2. Range of S : K1~K32,767; unit: hour. Range of D 1 in 16-bit instruction: K0~K32,767. Range of D 1 +1 (current time less than an hour): K0 ~K3,599; unit: second. 3. When the ON-time of the drive contact reaches the set-point value, output device will be ON. The instruction can be applied for controlling the working hours of machine or conducting preventive maintenance. 4.
After output device is ON, the current time will still be measured in D 1 . 5. In 16-bit instruction, when the current time measured reaches the maximum 32,767 hours / 3,599 seconds, the timing will stop. To restart the timing, D 1 and D 1 + 1 have to be reset. 6. In 32-bit instruction, when the current time measured reaches the maximum 2,147,483,647 hours / 3,599 seconds, the timing will stop. To restart the timing, D 1 ~ D 1 + 2 have to be reset. 7. If operand S uses device F, only 16-bit instruction is available. 8. HOUR instruction can be used for four times in the program. Program Example 1: reaches 100 hours, Y0 will be ON and D0 will record the current time measured (in hour).
D1 will In 16-bit instruction, when X0 = ON, Y20 will be ON and the timing will start. When the timing record the current time less than an hour (0 ~ 3,599; unit: second).. X0 Y20 Y20 HOUR Program Example 2: 3-423 API Mnemonic Operands Function Controllers 169 D HOUR Hour meter ES2/EX2 SS2 SA2 SX2 SE Typ e OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F HOUR: 7 steps DHOUR: 13 steps S * * * * * * * * * * * D 1 * D 2 * * * PULSE 16-bit 32-bit SA2 SA2 SA2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 SE SE SE K100 D0 Y0