3. Instruction Set 4. When applying GPS instruction, COM1 has to be applied in Master mode, i.e. M1312 has to be enabled to sending request. In addition, M1314 = ON indicates receiving completed. M1315 = ON indicates receiving error. (D1250 = K1, receiving time-out; D1250 = K2, 5. Associated M flags and special D registers: checksum error) 6. Before applying the received GPS data, please check the value in D +9. If D +9 = 0, the GPS data is invalid. 7. If data receiving error occurs, the previous data in D registers will not be cleared, i.e. the previous received data remains intact. Program example: Sentence identifier: $GPGGA 1.
Set COM1communication protocol first Set communication protocol as 9600,8,N,1 Retain communication setting Set receiving time-out as 2s 2. Then enable M0 to execute GPS instruction with sentence identifier $GPGGA M0 M0 M1314 M1315 Y0 Y1 3-433 No. Function M1312 COM1 (RS-232) sending request M1313 COM1 (RS-232) ready for data receiving M1314 COM1 (RS-232) data receiving completed M1315 COM1 (RS-232) data receiving error M1138 Retaining communication setting of COM1 D1036 COM1 (RS-232) Communication protocol D1249 COM1 (RS-232) data receiving time-out setting. (Suggested value:
>1s) D1250 COM1 (RS-232) communication error code M1 MOV H81 D1036 SET M1138 Retain MOV K2000 D1249 H81 D1036 K2000 D1249 SET M1312 GPS K0 D0